PLANET XGS3-24040 - Manual (Page 638)

XGS3 Command Guide
38-67
Command Mode: Interface Configuration Mode
Usage Guide: The command is only working under global multicast destination-control enabled, after
configuring the command, if IGMP-SPOOPING is enabled, for adding the interface to multicast group,
and match configured access-list, such as matching: permit, the interface can be added, otherwise do not
be added.
Example:
Switch(config)#inter e 1/4
Switch(Config-If-Ethernet 1/4)#ip multicast destination-control access-group 6000
Switch (Config-If-Ethernet1/4)#
38.8.4 ip multicast destination-control access-group
(sip)
Command: ip multicast destination-control <IPADDRESS/M> access-group <6000-7999>
no ip multicast destination-control <IPADDRESS/M> access-group <6000-7999>
Function: Configure multicast destination-control access-list used on specified net segment, the “no ip
multicast destination-control <IPADDRESS/M> access-group <6000-7999>“ command deletes this
configuration.
Parameter: <IPADDRESS/M>: IP address and mask length;
<6000-7999>: Destination control access-list number.
Default: None
Command Mode: Global Mode
Usage Guide: The command is only working under global multicast destination-control enabled, after
configuring the command, if IGMP-SPOOPING or IGMP is enabled, for adding the members to multicast
group. If configuring multicast destination-control on specified net segment of transmitted igmp-report,
and match configured access-list, such as matching permit, the interface can be added, otherwise do not
be added. If relevant group or source in show ip igmp groups detail has been established before
executing the command, it needs to execute clear ip igmp groups command to clear relevant groups in
Admin mode.
Example:
Switch(config)#ip multicast destination-control 10.1.1.0/24 access-group 6000
38.8.5 ip multicast destination-control access-group
(vmac)
Command: ip multicast destination-control <1-4094> <macaddr>access-group <6000-7999>
no ip multicast destination-control <1-4094> <macaddr>access-group <6000-7999>
Function: Configure multicast destination-control access-list used on specified vlan-mac, the “no ip
multicast destination-control <1-4094> <macaddr >access-group <6000-7999>”command deletes
this configuration.
Parameter: <1-4094>: VLAN-ID;