Mounting, Connections – Basler Electric BE1-11m User Manual
Page 508
496
9424200996 Rev L
Mounting
RTD modules are contained in a potted plastic case and may be mounted in any convenient position. The
construction of an RTD module is durable enough to mount directly on a motor using UNC ¼-20 or
equivalent screws. Hardware selection should be based on any expected shipping/transportation and
operating conditions. The torque applied to the mounting hardware should not exceed 65 in-lb (7.34 N•m).
See Figure 314 for RTD module overall dimensions. All dimensions are shown in inches with millimeters
in parenthesis.
Figure 314. RTD Module Overall Dimensions
Connections
RTD module connections are dependent on the application. Incorrect wiring may result in damage to the
module.
Note
Be sure that the RTD module is hard-wired to earth ground with no
smaller than 12 AWG (3.31 mm
2
) copper wire attached to the chassis
ground terminal on the module.
8.38 [212.75]
6.75 [171.35]
6.38 [161.95]
2.24 [56.84]
P0069-19
RTD Module
BE1-11m