Festo Электромотор MTR-DCI - Manual (Page 123)

5. Commissioning
5-25
Festo P.BE-MTR-DCI-CO-EN en 1209a
CAN power supply (CAN Voltage Supply)
(not with MTR-DCI-32)
– The following settings are possible: internal/external.
– The default setting is the internal voltage supply.
For information on the CAN voltage supply, see chapter 3.6,
Tab. 3/8 and Tab. 3/9.
Set the CAN voltage supply as follows:
1. Select [Settings] [CAN parameter] [CAN volt. supply]
(see also section 4.5).
2. Press <Enter> to display the current setting.
3. Use the arrow keys to set the desired power supply.
4. Accept the setting with OK <Enter>.
The setting takes effect immediately, and is saved against
network failure.
} Settings
CAN parameter
CAN volt.supply
CAN volt.supply
internal
ESC<Menu>
EDIT <--> OK <Enter>