Festo Электромотор MTR-DCI - Manual (Page 90)

4. Control panel (only type MTR-DCI-...-H2)
4-18
Festo P.BE-MTR-DCI-CO-EN en 1209a
4.5.2 [Settings] [Axis parameter]
Teach mode for setting the axis parameters
• In order to set the measuring system select the following
parameters. Observe the instructions in chapter 5.2.4.
[Axis parameter] Description
[Zero point] Offset axis zero point
[Abs.min.pos] Stroke limitation: Software end position,
negative
[Abs.max.pos] Stroke limitation: Software end position,
positive
[SAVE...] Save parameters in EEPROM
Tab. 4/7: Menu [Settings] [Axis parameter]
<- -> You can move the axis into the desired position with
the arrow buttons.
OK You can accept the selection with the <Enter> button.
ESC With the <Menu> button you can interrupt the activ-
ity and return to the higher-order menu.
• Choose [SAVE...] to save the parameter settings. Only then
will the settings be retained even when the power supply
is switched off or if there is a power failure.