Festo Электромотор MTR-DCI - Manual (Page 92)

4. Control panel (only type MTR-DCI-...-H2)
4-20
Festo P.BE-MTR-DCI-CO-EN en 1209a
4.5.4 [Settings] [Position set]
Programming the position record table
• Select the number of the desired position set. The follow-
ing settings refer to the currently selected position set.
Note also the instructions on programming the position
sets in chapter 5.2.5.
[Position set] Param. Description
[Position no.] No. Number of the position set
[Pos set mode] [absolute/
relative] Positioning mode
absolute = absolute position specification, related to the
project zero point
relative = relative position specification, related to the current
position
[Position] xt Teach mode for setting the target position in the selected
measuring system e.g. [mm].
Do not teach the positions until the reference system has been
defined by means of a reference run. (see chapter 4.4.3)
[Velocity] v Positioning speed in the selected measuring system e.g. [mm/s]
[SAVE...] Save parameters in EEPROM
Tab. 4/9: Menü [Settings] [Position set]
<- -> You can move the axis into the desired position or
select the parameter setting with the arrow buttons.
OK You can accept the selection with the <Enter> button.
ESC With the <Menu> button you can interrupt the activ-
ity and return to the higher-order menu.
• Choose [SAVE...] to save the parameter settings. Only then
will the settings be retained even when the power supply
is switched off or if there is a power failure.