Festo Электромотор MTR-DCI - Manual (Page 64)

3. Installation
3-12
Festo P.BE-MTR-DCI-CO-EN en 1209a
Information on commissioning and parametrizing the
MTR-DCI via the serial interface can be found in chapter 5.3
and in the help system for the FCT software package.
Information on transmitting CI commands via the serial
interface can be found in the appendix C.3.2.
Note
The RS232 interface is not electrically isolated. It is not
suitable for permanent connection to PC systems, nor for
use as a control interface.
• Use this terminal only for commissioning.
• Remove the programming cable in continuous opera-
tion.
• Seal the terminal with the protective cap supplied (ISK-
M8).