Festo Электромотор MTR-DCI - Manual (Page 27)

1. System overview
1-5 Festo P.BE-MTR-DCI-CO-EN en 1209a
All parameters are entered or displayed in the relevant set
measuring units.
Measuring units Control
panel FCT Field bus
Linear axis Metric Metric measuring units,
e. g. mm, mm/s, mm/s
2
x x –
Inches
1)
Imperial measuring units,
e. g. inch, inch/s, inch/s
2
– x –
Increments Increment-based measuring
units, e. g. inc, inc/s, inc/s
2
– – x
Rotation axis Degree Angle dimension
360° = 1 revolution
e. g. deg, deg/s, deg/s
2
x x –
Revolutions
2)
Number of revolutions
e. g. rev, rev/min, rev/min
2
x – –
Increments Increment-based measuring
units, e. g. inc, inc/s, inc/s
2
– – x
1)
Only with FCT when setting up a project
2)
Setting only with control panel [Settings] [Axis type] [Rotation axis]
Setting the units of measurement influences only the display.
All parameters are saved internally in the controller in in-
crements (inc, inc/s, inc/s
2
...) and are not converted until
they are written or read.
Dimensions transmitted by the RS232 or by the field bus refer
to an increment basis (conversion see appendix A.4)