Festo Электромотор MTR-DCI User Manual
Page 182
5. Commissioning
5-84
Festo P.BE-MTR-DCI-CO-EN en 1209a
Device connection
Caution
The RS232 interface is not electrically isolated. It is not
intended for permanent connection to PC systems or as
a controller interface.
•
Use the connection only for parametrizing and diag-
nosis.
Control during operation
Warning
There is a danger of injury.
Faults in parametrizing can cause injury to people and
damage to property when the controller is enabled.
•
Only enable the controller if the axis system has been
installed and parametrized by technically qualified staff.
Caution
Note the manufacturer's specifications for the permitted
operating conditions of the motors and drives used, e. g.
the permitted positioning speeds.
Caution
Damage to components of the DMES-...
Movement to the mechanical end positions is not per-
mitted during operation. When movement is made to the
end positions with a heavy load, blockage may occur in the
end positions.
Note
Any functions implemented within the framework of
the EMERGENCY-STOP concept must also be taken into
account in the control programs