Festo Электромотор MTR-DCI - Manual (Page 75)

4. Control panel (only type MTR-DCI-...-H2)
4-3
Festo P.BE-MTR-DCI-CO-EN en 1209a
The control panel of the motor unit MTR-DCI-...- H2 enables
commissioning directly on the MTR-DCI. An overview of the
key and menu functions can be found in this chapter.
Commissioning with the control panel is described starting in
chapter 5.2.
With the MTR-DCI-...- R2 (without control panel) you can com-
mission the MTR-DCI via the RS232 interface (with FCT soft-
ware). Instructions on this can be found in section 5.3.
Caution
Simultaneous access of control functions and operating
functions by the FCT and the control panel can cause
faults.
• Make sure that FCT and the control panel are not used at
the same time.
• If necessary, use the possibility of blocking parametriz-
ing and positioning functions via the control panel
(HMI access, see section 5.5.2)
Note
If applicable, remove any protective foil on the display
before commissioning.