Festo Электромотор MTR-DCI - Manual (Page 17)

Contents and general safety instructions
XV Festo P.BE-MTR-DCI-CO-EN en 1209a
Information on the version
The hardware version specifies the version status of the
mechanical parts and electronics of the MTR-DCI. The firm-
ware version specifies the version status of the operating
system of the MTR-DCI.
You can find the specifications on the version status as fol-
lows:
– Hardware version and firmware version in the Festo
Configuration Tool with active device connection to
the MTR-DCI under “Device data.”
– Firmware version on the control panel under [Diagnostic]
[Software information]
Firmware
version What is new ? Which FCT-PlugIn ?
V1.00 Supports the listed sizes of the MTR-DCI-CO in combina-
tion with the following axes from Festo:
Motor unitAxes
MTR-DCI-32...
DMES-18; DNCE-32
MTR-DCI-42... DMES-25; DNCE-32/40
MTR-DCI-52... DMES-40; DNCE-40/63
MTR-DCI-62... DMES-63; DNCE-63
MTR-DCI-CO V2.0.0
Tab. 0/2: Firmware versions