Festo Электромотор MTR-DCI - Manual (Page 78)

4. Control panel (only type MTR-DCI-...-H2)
4-6
Festo P.BE-MTR-DCI-CO-EN en 1209a
4.2 The menu system
4.2.1 Accessing the main menu
When the power supply is switched on, the MTR-DCI auto-
matically carries out an internal check. At first the display
briefly shows the Festo Logo then changes to the status dis-
play. The status display shows the following information:
– the type designation of your MTR-DCI,
– the current position of the drive x a = ...,
– the current setting of the device control
(HMI = Human Machine Interface).
The current button function will be displayed in the lower
lines of the display:
<Menu> The main menu is accessed from the status dis-
play with the <Menu> button.
4.2.2 Selecting a menu command
<- -> With the arrow buttons on the control panel you
can select a menu command from the list. The
current selection is marked with an arrow (
}
Diagnostic). Select
S in order to display further
menu commands.
ESC With the <menu> button you can interrupt the
current entry and return to the status display
or from a sub-menu to the higher-order menu.
OK With the <Enter> button you can confirm the cur-
rent selection or entry.
MTR-DCI...
X
a
= 0.00 mm
HMI:off
<Menu>
} Diagnostic
Positioning
Settings
S
ESC <Menu>
<-->
OK <Enter>
} HMI control
LCD adjustment
s ESC <Menu>
<-->
OK <Enter>