Festo Электромотор MTR-DCI - Manual (Page 84)

Move position set
Position no.
[1...31] = _?
ESC <Menu>
EDIT <--> OK <Enter>
Move position set
Attention! Motor moves
ESC <Menu>
START <Enter>
4. Control panel (only type MTR-DCI-...-H2)
4-12
Festo P.BE-MTR-DCI-CO-EN en 1209a
Selecting positioning travel or reference travel:
1. Select the menu [Positioning] in the main menu.
2. Select the menu command:
– [Move position set] for testing a certain position set in
the position record table (see chapter 4.4.1).
– [Demo posit tab] in order to execute all position sets
in the position record table one after the other.
– [Homing] reference travel for determining the measur-
ing system (see chapter 4.4.3).
4.4.1 [Positioning] [Move position set]
Note
Do not start a positioning run until the reference system
has been defined by means of a reference run.
For testing a particular position record in the position record
table.
1. Select the number of the position set.
<- -> You can set the desired number with the arrow
buttons.
OK You can accept the selection with the <Enter> button.
ESC With the <Menu> button you can interrupt the activ-
ity and return to the higher-order menu.
2. Start the positioning procedure with START <Enter>.
During positioning travel the following information is
displayed:
– the active positioning set e.g. Pos 2
} Positioning
Move position set
Demo posit tab
Homing