Digi NS9750 - Manual (Page 55)

w w w . d i g i e m b e d d e d . c o m 3 1
N S 9 7 5 0 P i n o u t
PCI/CardBus signals
Most of the CardBus signals are the same as the PCI signals. Other CardBus signals are
unique and multiplexed with PCI signals for the NS9750. Table 9 shows these unique
signals. Figure 8 illustrates how to terminate an unused PCI.
AD22 pci_int_d_n
2
N/A I PCI interrupt request D
AE26 pci_reset_n
3
N/A I/O PCI reset, output if internal central resource
enabled
AB24 pci_clk_in U N/A I PCI clock in. (Connected to pci_clk_out or an
externally generated PCI reference clock.)
AA23 pci_clk_out N/A O PCI clock out
PCI signal CardBus signal CardBus type Description
INTA# CINT#
4
Input CardBus interrupt pin. The INTA2PCI pin in the
PCI Miscellaneous Support register must be set
to 0.
INTB# CCLKRUN#
4
Bidir CardBus pin used to negotiate with the external
CardBus device before stopping the clock.
Allows external CardBus device to request that
the clock be restarted.
INTC# CSTSCHG
5
Input CardBus status change interrupt signal.
GNT1# CGNT#
4
Output Grant to external CardBus device from
NS9750’s internal arbiter.
Table 9: CardBus IO multiplexed signals
Pin # Signal name U/D
OD
(mA)
I/O Description
Table 8: PCI interface pinout