Horizontal timing for stn displays – Digi NS9750 User Manual
Page 848
L C D t i m i n g
8 2 4
N S 9 7 5 0 H a r d w a r e R e f e r e n c e
5
These data widths are supported:
— 4-bit mono STN single panel
— 8-bit mono STN single panel
— 8-bit color STN single panel
— 4-bit mono STN dual panel (8 bits to LCD panel)
— 8-bit mono STN dual panel (16 bits to LCD panel)
— 8-bit color STN dual panel (16 bits to LCD panel)
— 24-bit TFT
— 18-bit TFT
6
See "LCDTiming0," beginning on page 580, and "LCDTiming1," beginning on page 582, for definitions of
the bit fields referred to in this table.
7
Note that data is sampled by the LCD panel on the falling edge of the
CLCP
in Figure 135, "LCD output
timing," on page 826). If the polarity of
CLCP
is inverted, this parameter is relative to
CLCP
falling, instead.
8
C
load
= 10pf on all outputs.
9
CLCP high and low times specified as 50% of the clock period +/- 0.5ns.
10
Maximum allowable LCD panel clock frequency is 80 MHz.
Horizontal timing for STN displays
Figure 129: Horizontal timing for STN displays
L15
L15
L6
L6
L17
L3
L4
L2
L1
L3
L2
Valid Display Data
Blanking
Blanking
CLLP
CLCP
CLD[7:0]