Digi NS9750 - Manual (Page 92)

S y s t e m c o n t r o l p r o c e s s o r ( C P 1 5 ) r e g i s t e r s
6 8 N S 9 7 5 0 H a r d w a r e R e f e r e n c e
found, one of those lines is cleaned. The test and clean DCache instruction also
returns the status of the entire DCache in bit 30.
Note:
The test and clean DCache instruction
MRC p15, 0, r15, c7, c10, 3
is a special
encoding that uses
r15
as a destination operand. The PC is not changed by
using this instruction, however. This
MRC
instruction also sets the
condition code flags.
If the cache contains any dirty lines, bit 30 is set to 0. If the cache contains no dirty
lines, bit 30 is set to 1. Use the following loop to clean the entire cache:
tc_loop: MRC p15, 0, r15, c7, c10, 3 ; test and clean
BNE tc_loop
Test, clean, and invalidate DCache instruction
The test, clean, and invalidate DCache instruction is the same as the test and clean
DCache instruction except that when the entire cache has been cleaned, it is
invalidated. Use the following loop to test, clean, and invalidate the entire DCache:
tci_loop: MRC p15, 0, r15, c7, c14, 3 ; test clean and invalidate
BNE tci_loop
R8:TLB Operations register
Register R8 is a write-only register that controls the translation lookaside buffer
(TLB). There is a single TLB used to hold entries for both data and instructions. The
TLB is divided into two parts:
Set-associative
Fully-associative
The fully-associative part (also referred to as the lockdown part of the TLB) stores
entries to be locked down. Entries held in the lockdown part of the register are
preserved during an invalidate-TLB operation. Entries can be removed from the
lockdown TLB using an invalidate TLB single entry operation.
There are six TLB operations; the function to be performed is selected by the
opcode_2
and
CRm
fields in the
MCR
instruction used to write register R8. Writing other
opcode_2
or
CRm
values is
UNPREDICTABLE
. Reading from this register is
UNPREDICTABLE
.
Use the instruction shown in Table 28 to perform TLB operations.