17 switchport mode access, 18 switchport mode trunk – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 127
CanogaOS Command Line Reference
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 127 of 855
Related Commands
switchport mode access
6.17 switchport mode access
Use this command to set the switchport mode to access.
Command Syntax
switchport mode access
access: set the switchport mode to access
Command Mode
Interface configuration
Usage
The access mode is usually used to connect the port to a terminal device, for example a PC.
When the mode is changed, both the mac learned dynamically and configured statically on the port will
be cleared.
Examples
This example shows how to set the switchport mode to access.
Switch(config-if)# switchport mode access
Related Commands
switchport mode trunk
6.18 switchport mode trunk
Use this command to set the switchport mode to trunk.
Command Syntax
switchport mode trunk
Command Mode
Interface configuration
Usage
The trunk mode is usually used to connect the port with other switch.
The trunk mode is usually used to connect the port with host device.