CANOGA PERKINS CanogaOS Command Reference - Manual (Page 306)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 306 of 855
16.42 ip extcommunity-list standard
Use this command to create and delete a standard extended community list.
Use the no parameter with this command to delete the extended community-list entry.
Command Syntax
(no) ip extcommunity-list STANDARD deny|permit .AA:NN
no ip extcommunity-list <1-99>
no ip extcommunity-list standard WORD
STANDARD = <1-99>|(standard WORD)
<1-99> Standard extcommunity list number
standard Specifies a standard extcommunity list
WORD Standard extcommunity list name
deny Specifies the extcommunity to reject
permit Specifies the extcommunity to accept
AA:NN Specifies the valid value for an extcommunity number. This format represents the 32 bit
extcommunities value, where AA is the high order 16 bits and NN is the low order 16 bits in digit
format.
Command Mode
Configure mode
Examples
Switch# configure terminal
Switch(config)# ip extcommunity-list 36 permit 5675:50
Switch(config)# ip extcommunity-list standard CLIST permit 7645:70
Related Commands
ip extcommunity-list expanded, show ip extcommunity-list
16.43 mpls-resolution
Use this command to allow BGP to query the NSM for preexisting LSPs (from RSVP or LDP) enabling BGP to
map prefixes to these LSPs.
Use the no parameter with this command to reset all peer information in BGP.
Command Syntax
(no) mpls-resolution
Command Mode
Router mode