CANOGA PERKINS CanogaOS Command Reference - Manual (Page 221)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 221 of 855
Command Syntax
arp timeout seconds
no arp timeout
seconds Time (in seconds) that an entry remains in the ARP cache.
Default
3600 seconds (1 hour)
Command Mode
Interface configuration
Usage
This command is ignored when issued on interfaces that do not use ARP. The show interface EXEC
command displays the ARP timeout value. The value as seen in the following example from the show
interface command:
ARP timeout 01:00:00, ARP retry interval 1s
Examples
The following example sets the ARP timeout to 12000 seconds to allow entries to time out more quickly
than the default:
Switch(config-if)# arp timeout 12000
Related Commands
show interface
13.3 clear arp-cache
To refresh dynamically created entries from the Address Resolution Protocol (ARP) cache, use the
clear arp-cache command in privileged EXEC mode.
Command Syntax
clear arp-cache [[vrf vrf-name] interface interface-name]
vrf vrf-name (Optional) Refreshes only the ARP table entries for the
specified Virtual Private Network (VPN) routing and
forwarding (VRF) instance and the IP address specified by
the ip-address argument.
interface interface-name (Optional) Refreshes only the ARP table entries associated
with this interface.
Default
No default behavior or values.