CANOGA PERKINS CanogaOS Command Reference - Manual (Page 229)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 229 of 855
14.7 ip rip receive-packet
To enable the interface to receive Routing Information Protocol (RIP) packets, use the ip rip
receive-packet command in interface configuration mode. To disable to receive RIP packets, use the
no form of this command.
Command Syntax
ip rip receive-packet
no ip rip receive-packet
Default
This command is enabled by default.
Command Mode
Interface configuration
Usage
Use this command to enable or disable the capability of receiving RIP packets, whether the network of
this interface is added into RIP or not.
Examples
The following example enables the reception of RIP packets:
Switch(config-if)# ip rip receive-packet
Related Commands
ip rip receive version
14.8 ip rip send version
To specify a Routing Information Protocol (RIP) version to send on an interface basis, use the ip rip
send version command in interface configuration mode. To follow the global version rules, use the no
form of this command.
Command Syntax
ip rip send version {1 [2] | 2 [1] | 1-compatible}
no ip rip send version
1 (Optional) Sends only RIP Version 1 packets out the interface.
2 (Optional) Sends only RIP Version 2 packets out the interface.
1-compatible (Optional) Sends RIP Version 2 packets out the interface with broadcast IP
address.