22 keepalive-interval – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 481
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 481 of 855
25.22 keepalive-interval
Use this command to set the global value for the interval after which keep-alive packets are sent
out. Use the no parameter to revert to default keep-alive interval.
Command Syntax
(no) keepalive-interval number
Syntax Description
number
Specifies the value of interval in seconds, the range is 10
to 21845
Command Mode
Router mode
Defaults
The default is 10 seconds.
Examples
In the following example, the keepalive-interval command is used to set the global value for the
interval after which keep-alive packets are sent out:
Switch# configure terminal
Switch(config)# router ldp
Switch(config-router)# keepalive-interval 635
Related Commands
keepalive-timeout
ldp keepalive-interval
ldp keepalive-timeout