26 ldp keepalive-interval – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 485
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 485 of 855
25.26 ldp keepalive-interval
Use this command to set the interval for sending keep-alive messages to the peer in order to
maintain a session. Use the no parameter to revert to the keep-alive interval set for the main LDP
process.
Command Syntax
(no) ldp keepalive-interval number
Syntax Description
number
Specifies the interval in seconds, the range is 10 to 21845
Command Mode
Interface mode
Defaults
The default is 10 seconds
Examples
In the following example, the ldp keepalive-interval command is used to set the interval for
sending keep-alive messages to the peer in order to maintain a session:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# ldp keepalive-interval 635
Related Commands
ldp keepalive-timeout