27 ldp keepalive-timeout – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 486
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 486 of 855
25.27 ldp keepalive-timeout
Use this command to set the keep-alive time-out value for rejecting a session with a peer. Use the
no parameter to revert to the keep-alive time-out set for the main LDP process.
Command Syntax
(no) ldp keepalive-timeout number
Syntax Description
number
Specifies the value in seconds, the range is 30 to 65535
Command Mode
Interface mode
Defaults
The default is 30 seconds.
Examples
In the following example, the ldp keepalive-timeout command is used to set the keep-alive
time-out value for rejecting a session with a peer:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# ldp keepalive-timeout 635
Related Commands
ldp keepalive-interval