CANOGA PERKINS CanogaOS Command Reference - Manual (Page 183)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 183 of 855
9.8 switchport dot1q-tunnel vlan mapping table
Use this command to apply vlan mapping table on selective dot1q tunnel port.
Command Syntax
switchport dot1q-tunnel vlan mapping table WORD
no switchport dot1q-tunnel vlan mapping table
Command Mode
Interface configuration
Usage
Apply exist vlan mapping table on dot1q-tunnel port. The type of dot1q-tunnel port should be selective.
Examples
Switch (config-if)# switchport dot1q-tunnel vlan mapping table mp
Related Commands
show vlan mapping table
9.9 dot1q ethertype
Use this command to dot1q ethertype.
Command Syntax
dot1q ethertype VALUE
VALUE: the ethertype value, could be 0x0000 ~ 0xFFFF
Command Mode
Interface configuration
Usage
Use this command to configure dot1q ethertype for switchport.
Examples
This example show how to configure eth-0-1’s ethertype to 0x88a8
Switch(config-if)# dot1q ethertype 88a8
Related Commands
None
9.10 l2protocol-tunnel enable
Use this command to enable l2protocol tunnel globally.