30 ldp targeted-peer-hold-time – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 489
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 489 of 855
25.30 ldp targeted-peer-hold-time
Use this command to set the time-out value that is the time that the router waits before rejecting an
adjacency with a targeted peer. Use the no parameter to revert to the targeted-peer value set for the
main LDP process.
Command Syntax
(no) ldp targeted-peer-hold-time number
Syntax description
number
Specifies the interval in seconds, the range is 3 to 65535
Command Mode
Interface mode
Defaults
The default is 45 seconds.
Examples
In the following example, the ldp targeted-peer-hold-time command is used to set the time-out
value that is the time that the router waits before rejecting an adjacency with a targeted peer:
Switch# configure terminal
Switch(config)# interface eth0
Switch(config-if)# ldp targeted-peer-hold-time 635
Related Commands
show ldp interface IFNAME
targeted-peer-hold-time