CANOGA PERKINS CanogaOS Command Reference - Manual (Page 479)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 479 of 855
25.20 hello-interval
Use this command to set the interval after which hello packets are sent out. Use the no parameter
to revert to default hello interval.
Command Syntax
(no) hello-interval number
Syntax Description
number Interval for sending periodic hello message to peers, the
range is 1 to 21845
Command Mode
Router mode
Defaults
The default is 5 seconds.
Examples
In the following example, the hello-interval command is used to set the interval after which hello
packets are sent out:
Switch(config)# router ldp
Switch(config-router)# hello-interval 35
Related Commands
hold-time
ldp hello-interval
ldp hold-time