47 targeted-peer – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 512
Advertising
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 512 of 855
25.47 targeted-peer
Use this command to specify a targeted LDP peer.
Command Syntax
targeted-peer A.B.C.D
Syntax description
A.B.C.D
Specifies the IPv4 address of the targeted peer.
Command Mode
Router mode
Defaults
This command has no default settings.
Examples
In the following example, the targeted-peer command is used to specify a targeted LDP peer:
Switch# configure terminal
Switch(config)# router ldp
Switch(config-router)# targeted-peer 10.10.10.10
Related Commands
Advertising