CANOGA PERKINS CanogaOS Command Reference - Manual (Page 698)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 698 of 855
The following example shows how to enable IP source guard on an interface:
Switch(config-if)# ip verify source ip-mac
Related Commands
35.4 show ip source binding
Use the show ip source binding privileged EXEC command to display the IP source bindings on the
switch.
Command Syntax
show ip source binding [interface interface-id]
interface interface-id Display IP source bindings for a specified interface.
Command Mode
Privileged EXEC
Usage
Examples
The following is sample output from the show ip source binding command:
Switch# show ip source binding
IP source guard binding table:
VLAN MAC Address Type IP Address Interface State
================================================================
1 00:01:00:01:00:01 static 10.10.1.1 eth-0-13 Disabled
Related Commands
ip source binding