CANOGA PERKINS CanogaOS Command Reference - Manual (Page 542)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 542 of 855
debug bgp mpls
27.4 exit-address-family
Use this command to exit address-family-vrf or address-family-vpnv4 mode.fd
Command Syntax
exit-address-family
Command Mode
Address Family-vrf and Address Family-vpnv4 mode.
Examples
The following example shows the change in prompt after using the exit-address-family command to exit the
address-family mode.
Switch(config)# router bgp 100
Switch(config-router)# address-family vpnv4 unicast
Switch(config-router-af)# exit-address-family
Switch(config-router)#
Related Commands
address-family vpnv4 unicast
27.5 neighbor activate
Use this command to enable the exchange of routing information with a peer router.
Use the no parameter with this command to disable this function.
Command Syntax
(no) neighbor NEIGHBORADDRESS activate
NEIGHBORADDRESS neighbor IP address. Use A.B.C.D form.
Default
Neighbor activation is enabled only under address-family ipv4.
Command Mode
Address Family-vpnv4 mode
Usage
Neighbor under address-family ipv4 is by default activated. For all other address-family, use this command to
enable neighbor in order to exchange routing information of specific address-family with neighbor.