CANOGA PERKINS CanogaOS Command Reference - Manual (Page 184)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 184 of 855
Command Syntax
L2protocol-tunnel enable
Command Mode
Interface configuration
Usage
Use this command to enable l2protocol tunnel globally.
Examples
This example shows how to enable l2protocol globally.
Switch(config)# l2protocol-tunnel enable
Related Commands
show l2protocol-tunnel
9.11 l2protocol-tunnel tunnel-dmac MAC
Use this command to l2protocol tunnel destination MAC address.
Command Syntax
l2protocol-tunnel tunnel-dmac MAC
No l2protocol-tunnel tunnel-dmac
MAC : BPDU tunnel’s destination MAC address, could be 0100.0CCD.CDD0-D2 or 010F.E200.0003
Command Mode
Global configuration
Usage
Use this command to l2 protocol tunnel dmac to 010F.E200.0003. System default tunnel-dmac is
0100.0ccd.cdd0.
Examples
Switch(config)# l2protocol-tunnel tunnel-dmac 010F.E200.0003
Related Commands
show l2protocol-tunnel
9.12 l2protocol-tunnel stp
Use this command to enable stp tunnel on port.
Command Syntax
l2protocol-tunnel stp