CANOGA PERKINS CanogaOS Command Reference - Manual (Page 696)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 696 of 855
35 IP Source Guard Commands
35.1 ip source binding
Use the ip source binding global configuration command on the switch to configure static IP source
bindings on the switch. Use the no form of this command to delete static bindings.
Command Syntax
ip source binding mac mac-address vlan vlan-id ip ip-address interface interface-id
no ip source binding mac mac-address vlan vlan-id ip ip-address interface interface-id
mac mac-address Specify a MAC address.
vlan vlan-id Specify a VLAN number. The range is 1 to 4094.
ip ip-address Specify an IP address.
interface interface-id Specify an interface on which to add or delete a binding entry.
Default
No IP source bindings are configured.
Command Mode
Global configuration
Usage
A static IP source binding entry has an IP address, its associated MAC address, and its associated
VLAN number. The entry is based on the MAC address and the VLAN number. If you modify an entry
by changing only the IP address, the switch updates the entry instead creating a new one.
Examples
The following is sample output from the ip source binding command:
Switch(config)# ip source binding mac 0001.1234.1234 vlan 1 ip 172.20.50.5 interface eth-0-1
Related Commands
show ip source binding
35.2 ip source maximal binding
To specify the maximum number of bindings for each interface, use the ip source maximal binding
command in global configuration mode. To restore to the default value, use the no form of this
command.
Command Syntax
ip source maximal binding per-port number