39 show ldp interface – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 499
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 499 of 855
25.39 show ldp interface
Use this command to display informations for all interfaces, or detailed information for a specific
interface.
Command Syntax
show ldp interface
[IFNAME]
Syntax description
IFNAME
The name of the interface, the format follows below:
eth-0-1, agg1, vlan1, etc.
Command Mode
Privileged Exec mode
Defaults
This command has no default settings.
Examples
In the following example, the show ldp interface command is used to display detailed information
for a specific interface:
Switch# show ldp interface eth-0-1
Status : Enabled
Primary IP Address : 192.168.3.4
Interface Type : Ethernet
Label Merge Capability : Merge Capable
Hello Interval : 5
Targeted Hello Interval : 15
Hold Time : 15
Targeted Hold Time : 45
Keepalive Interval : 10
Keepalive Timeout : 30
Advertisement Mode : Downstream On Demand
Label Retention Mode : Liberal
Administrative Groups : Cen1
: Cen2
Related Commands