3 dhcp-server (interface) – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 816
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 816 of 855
Default
No DHCP server group is defined.
Command Mode
Global configuration
Usage
Examples
The following is sample output from the dhcp-server command:
Switch(config)# dhcp-server 1 1.1.1.1 2.2.2.2 3.3.3.3
Related Commands
service dhcp
dhcp-server (interface)
42.3 dhcp-server (interface)
To add an interface into a DHCP server group, use the dhcp-server command in interface
configuration mode. To remove this interface from the DHCP server group, use the no form of this
command.
Command Syntax
dhcp-server number
no dhcp-server
number
Number of the DHCP server group. The range is from 1 to 16.
Default
No DHCP server group is added.
Command Mode
Interface configuration
Usage
Examples
The following is sample output from the dhcp-server command:
Switch(config)# interface eth-0-1
Switch(config-if)# dhcp-server 1