CANOGA PERKINS CanogaOS Command Reference - Manual (Page 620)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 620 of 855
In the following example, the traceroute mpls ipv4 command is used to initiate tracing the route
traversed by specifying the destination type as a Label Distribution Protocol (LDP) IPv4 address.
Switch# traceroute mpls ipv4 1.1.1.1/24 destination 127.0.0.1 dsmap detail flags
interval 100 repeat 100 reply-mode 1 source 1.1.1.1 timeout 100 ttl 200
Related Commands
ping mpls ipv4