CANOGA PERKINS CanogaOS Command Reference - Manual (Page 255)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 255 of 855
Usage
You can set the metric manually using this command, if you need to change the default. Using the
bandwidth command changes the link cost as long as this command is not used.
The link-state metric is advertised as the link cost in the router link advertisement.
In general, the path cost is calculated using the following formula:
10 8 / bandwidth
Examples
The following example sets the interface cost value to 65:
Switch(config-if)# ip ospf cost 65
Related Commands
15.17 ip ospf database-filter all out
To filter outgoing link-state advertisements (LSAs) to an Open Shortest Path First (OSPF) interface,
use the ip ospf database-filter all out command in interface configuration mode. To restore the
forwarding of LSAs to the interface, use the no form of this command.
Command Syntax
ip ospf database-filter all out
no ip ospf database-filter all out
Default
This command is disabled by default. All outgoing LSAs are flooded to the interface.
Command Mode
Interface configuration
Usage
Examples
The following example prevents flooding of OSPF LSAs to broadcast, nonbroadcast, or point-to-point
networks reachable through the interface eth-0-1:
interface eth-0-1
ip ospf database-filter all out
Related Commands