CANOGA PERKINS CanogaOS Command Reference - Manual (Page 480)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 480 of 855
25.21 hold-time
Use this command to set the global value for the hold-time after which the LSR rejects
adjacencies. Use the no parameter to revert to the default hold time.
Command Syntax
(no) hold-time number
Syntax Description
number Specifies the hold-time value in seconds, the range is 3 to
65535
Command Mode
Router mode
Defaults
The default is 15 seconds.
Examples
In the following example, the hold-time command is used to set the global value for the hold-time
after which the LSR rejects adjacencies:
Switch# configure terminal
Switch(config)# router ldp
Switch(config-router)# hold-time 635
Related Commands
hello-interval
ldp hello-interval
ldp hold-time