7 vpls-mtu – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 601
Advertising
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 601 of 855
30.7 vpls-mtu
Use this command to set mtu for VPLS instance.
Note:
If set the MTU value for the VPLS instance, LDP will advertise this value to peers
in the instance.
Command Syntax
vpls-mtu MTU
Syntax Description
MTU
MTU value for the VPLS instance, the range is from 576
to 65535.
Command Mode
VPLS mode
Defaults
This command has no default settings.
Examples
In the following example, the vpls-mtu command is used to set mtu for VPLS instance:
Switch# configure terminal
Switch(config)#mpls vpls vpls1 1
Switch(config-vpls)# vpls-mtu 55555
Related Commands
no vpls-mtu
Advertising