25 ldp hold-time – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 484
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 484 of 855
25.25 ldp hold-time
Use this command to set the hold-time value after which the LSR rejects adjacencies. Use the no
parameter to revert to the hold-time value set for the main LDP process.
Command Syntax
(no) ldp hold-time number
Syntax Description
number
Specifies the hold-time value in seconds, the range is 3 to
65535
Command Mode
Interface mode
Defaults
The default is 15 seconds.
Examples
In the following example, the ldp hold-time command is used to set the hold-time value after
which the LSR rejects adjacencies:
Switch # configure terminal
Switch (config)# interface eth-0-1
Switch (config-if)# ldp hold-time 635
Related Commands
hello-interval
hold-time
ldp hello-interval