9 configure cc transmission interval – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 193
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 193 of 855
Command Syntax
ethernet cfm cc enable level LEVEL vlan VLAN_ID
no ethernet cfm cc enable level LEVEL vlan VLAN_ID
Command Mode
Configure mode
Default
The default is disable.
Usage
The level ID identifies the domain to which configuration applies.
1) Enter enable to enable CFM cc for the domain level.
2) 20 Enter a maintenance level as a level number (0 to 7) or as any for all maintenance levels.
3) Enter the VLANs to apply the check to, as a VLAN-ID (1 to 4095), a range of VLAN-IDs separated
by a hyphen, a series of VLAN IDs separated by commas,or any for any VLANs.
4)
Examples
Switch#configure terminal
Switch(config)# ethernet cfm cc level 7 vlan 30 interval 5
Related Commands
10.9 Configure CC transmission interval
Use this command to set cc transmissions interval.
Command Syntax
ethernet cfm cc level LEVEL vlan VLAN_ID (interval ( 1000 | 10000 | 60000 | 600000))
Command Mode
Configure mode
Default
Transmit interval default value is 10000ms.
Usage