CANOGA PERKINS CanogaOS Command Reference - Manual (Page 590)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 590 of 855
29.4 no mpls-l2-circuit
Use this command to unbind an interface to a MPLS Layer 2 Virtual Circuit.
Command Syntax
no mpls-l2-circuit NAME
Syntax Description
NAME Identifying string for MPLS Layer-2 Virtual Circuit.
Command Mode
Interface mode
Defaults
This command has no default settings.
Examples
In the following example, the no mpls-l2-circuit command is used to unbind an interface to a
MPLS Layer 2 Virtual Circuit:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config)# no mpls-l2-circuit pw1
Related Commands
mpls-l2-circuit