CANOGA PERKINS CanogaOS Command Reference - Manual (Page 536)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 536 of 855
Examples
In the following example, the show mpls mapped-routes command is used to display mapped
MPLS routes:
Switch# show mpls mapped-routes
Mapped-route IPv4 FEC
11.11.11.0/24 5.5.5.0/24
In the following example, the show mpls ftn-forwarding command is used to display MPLS
Forwarding table including mapped MPLS routes:
Switch# show mpls ftn-forwarding
FEC Out-Label Nexthop Out-Intf
3.3.3.0/24 3 2.2.2.2 eth-0-9
5.5.5.0/24 1026 2.2.2.2 eth-0-9
11.11.11.0/24 1026 2.2.2.2 eth-0-9
202.198.25.2/32 1025 2.2.2.2 eth-0-9
Related Commands
show mpls ftn-forwarding
show mpls ftn-database
26.20 show mpls statistics
Use this command to display statistics of MPLS packets.
Comm a nd Syntax
show mpls statistics {all | entry | ftn | ilm | l2-circuit | vpls | vrf}
Syntax description
all All statistics information.
entry All entry number statistics information.
ftn MPLS FTN statistics information.
ilm MPLS ILM statistics information.
l2-circuit MPLS Layer-2 Virtual Circuit statistics information.
vpls MPLS VPLS statistics information.
vrf MPLS vrf statistics information.