CANOGA PERKINS CanogaOS Command Reference - Manual (Page 171)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 171 of 855
Only the interface in trunk mode can be set as primary or secondary interface.
Examples
This example shows how to set interface eth-0-9 as primary interface for ERPS domain 11 ring 1.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface eth-0-9
Switch(config-if)# switchport mode trunk
Switch(config-if)# switchport trunk allowed vlan add 15
Switch(config-if)# exit
Switch(config)# erps 11 ring 1 primary interface eth-0-9
And you can check the result by using “show erps 11” command.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16
ERPS domain sub control VLAN ID: 15
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 5 second(s)
ERPS ring ID: 1
ERPS ring level: sub
ERPS ring 1 node mode: transit
ERPS ring 1 node state: idle
ERPS ring 1 primary interface name: eth-0-9
ERPS ring 1 secondary interface name: not configured
Related Commands
None
8.7 erps ring edge-mode
Use this command to set/unset specific ERPS ring instance edge node mode.
Command Syntax
erps ERPS_ID ring RING_ID edge-mode (edge | assistant-edge)
no erps <1-255> ring RING_ID edge-mode
ERPS_ID : <1-255> ERPS domain ID
RING_ID : <1-255> ERPS ring ID
edge-mode: erps edge mode
edge: edge node
assistant-edge: assistant-edge node