CANOGA PERKINS CanogaOS Command Reference - Manual (Page 404)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 404 of 855
Command Mode
Interface configuration mode
Usage
Executing this command on an interface removes the IP address on this interface, The IP address should be
reconfigured. This example shows how to add one interface to vrf:
Switch(config)#interface vlan1
Switch(config-if)#ip vrf forwarding ComA
Examples
Switch#configure t
Switch(config)#ip vrf ComA
Switch(config-vrf)#exi
Switch(config)#interface eth-0-1
Switch(config-if)#no switchport
Switch(config-if)#ip vrf forwarding ComA
Related Commands
ip vrf: Configure a VRF routing table
ip route vrf: Establishes static routes for VRF
20.4 ip route vrf
To establish static routes for a VPN routing and forwarding(VRF) instance, use the ip route vrf command in
global configuration mode. To disable static routes, use the no form of this command.
Command Syntax
i p route vrf VRF-NAME A.B.C.D/M A.B.C.D
ip route vrf NAME A.B.C.D A.B.C.D A.B.C.D
no i p route vrf VRF-NAME A.B.C.D/M (A.B.C.D|)
no i p route vrf VRF-NAME A.B.C.D A.B.C.D A.B.C.D
NAME: VPN Routing/Forwarding instance
A.B.C.D/M: IP destination prefix (e.g. 10.0.0.0/8)
A.B.C.D(prefix): IP route prefix for the destination, in dotted-decimal format
A.B.C.D(mask): Prefix mask for the destination, in dotted-decimal
A.B.C.D (next-hop-address): IP address of the next hop(the forwarding router
that can be used to reach that network.
Command Mode
Global configuration mode