CANOGA PERKINS CanogaOS Command Reference - Manual (Page 379)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 379 of 855
19.10.1.1 Command Syntax
match metric METRICVAL
no match metric
19.10.1.2 Syntax Description
METRICVAL <+/-metric>|<0-4294967295> The metric value.
19.10.1.3 Command Mode
Route-map mode
19.10.1.4 Defaults
No match metric is specified by default.
19.10.1.5 Examples
Switch# configure terminal
Switch(config)# route-map myroute permit 3
Switch(config-route-map)# no match metric 888999
19.10.1.6 Related Commands
match community
match as-path
set as-path
set community
match ip next-hop
19.11 match origin
Use this command to match origin code.
Use the no parameter with this command to disable this matching.
The origin attribute defines the origin of the path information. The egp parameter is indicated as
an e in the routing table, and it indicates that the origin of the information is learned via Exterior
Gateway Protocol. The igp parameter is indicated as an i in the routing table, and it indicates
the origin of the path information is interior to the originating AS.
The incomplete parameter is indicated as a ? in the routing table, and indicates that the origin of
the path information is unknown or learned through other means. If a static route is