CANOGA PERKINS CanogaOS Command Reference - Manual (Page 603)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 603 of 855
30.9 vpls-peer
Use this command to add a remote PE for VPLS instance.
Note:
If configure this command use key word – manual, the PW to this peer will not
issue by LDP or BGP, otherwise, the PW issued by LDP or BGP, can not create
PW fib manually.
Command Syntax
vpls-peer A.B.C.D {raw | tagged} [manual]
Syntax Description
A.B.C.D IP address of the peer node to be added.
raw Set Peer Virtual Circuits type to Raw mode.
tagged Set Peer Virtual Circuits type to Tagged mode.
manual PW for peer will created manually.
Command Mode
VPLS mode
Defaults
This command has no default settings.
Examples
In the following example, the vpls-peer command is used to add a remote PE for VPLS instance:
Switch# configure terminal
Switch (config)#mpls vpls vpls1 1
Switch (config-vpls)# vpls-peer 100.100.100.1 raw manual
Related Commands
no vpls-peer