13 mpls-vpls – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 607
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 607 of 855
30.13 mpls-vpls
Use this command to bind an interface to a VPLS instance.
Note:
The interface can not bind to same VPLS instance twice with different vlan tag;
the interface can not bind to VPLS instance and MPLS Layer 2 Virtual Circuit
both.
Command Syntax
mpls-vpls NAME [vlan VLANID]
Syntax description
NAME
Identifying string for VPLS instance.
VLANID
Vlan identifier, the range should be from 1 to 4094.
Command Mode
Interface mode
Defaults
Bind to VPLS instance without vlan tag.
Examples
In the following example, the mpls-vpls command is used to bind an interface to a VPLS
instance:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config)# mpls-vpls vpls1 vlan 100
Related Commands
no mpls-vpls