CANOGA PERKINS CanogaOS Command Reference - Manual (Page 208)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 208 of 855
Command Mode
Interface mode
Default
The default value for high threshold is none, meaning that no high threshold is configure. The default
value for the low threshold is 1. The default value of frame event window is 1000.
Examples
Switch# configure terminal
Switch (config)# interface eth-0-1
Switch (config-if)# ethernet oam link-monitor frame-seconds threshold high 5 low 2 window 200
11.9 ethernet oam link-monitor high threshold action
Use this command to define action when high threshold is detected. Use no form of the command to reset the
action.
Command Syntax
ethernet oam link-monitor high threshold action error-disable-interface
no ethernet oam link-monitor high threshold action error-disable-interface
error-disable-interface Disable the interface when high threshold is exceeded.
Command Mode
Interface mode
Default
When high threshold is exceeded it will generate only the corresponding link event and will not trigger
any interface events by default
Examples
Switch# configure terminal
Switch (config)# interface eth-0-1
Switch (config-if)# ethernet oam link-monitor high threshold action
error-disableinterface
11.10 ethernet oam link-monitor remote-failure
Use this command to define action when remote failure is detected. Use no form of the command to