CANOGA PERKINS CanogaOS Command Reference - Manual (Page 713)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 713 of 855
Interface configuration
Usage
Examples
The following is sample output from the dot1x reauthentication command:
Switch(config-if)# dot1x reauthentication
Related Commands
show dot1x
37.7 dot1x re-authenticae
Use the dot1x re-authenticate privileged EXEC command on the switch stack to manually initiate a
re-authentication of the specified IEEE 802.1x-enabled port.
Command Syntax
dot1x re-authenticate interface interface-name
interface-name The interface to re-authenticate.
Command Mode
Privileged EXEC
Usage
You can use this command to re-authenticate a client without waiting for the configured number of
seconds between re-authentication attempts (re-authperiod) and automatic re-authentication.
Examples
The following is sample output from the dot1x re-authente command:
Switch# dot1x re-authenticate interface eth-0-1
Related Commands
show dot1x
37.8 dot1x timeout
Use the dot1x timeout interface configuration command on the switch stack or on a standalone switch
to set IEEE 802.1x timers. Use the no form of this command to return to the default setting.