18 ip pim spt-switch-threshold infinity, 19 ip pim cisco-register-checksum – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 449
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 449 of 855
24.18 ip pim spt-switch-threshold infinity
Use this command to set the spt switch threshold to infinity.
To cancel this setting, use the no form of this command.
Command Syntax
ip pim spt-switch-threshold infinity
no ip pim spt-switch-threshold infinity
Command Mode
Global configuration
Usage
The DR will switch to spt immediately when received the first multicast packet by default.
Examples
This example shows how to set the spt switch threshold to infinity.
Switch(config)# ip pim spt-switch-threshold infinity
This example shows how to return the spt-switch-threshold to default.
Switch(config)# no ip pim spt-switch-threshold infinity
Related Commands
show ip pim sparse-mode spt-threshold
24.19 ip pim cisco-register-checksum
Use this command to calculate register checksum over whole packet (cisco compatibility).
To remove this setting, use the no form of this command.
Command Syntax
ip pim cisco-register-checksum [group-list list]
no ip pim cisco-register-checksum [group-list list]
list: the name of the access-list to be applied
Command Mode
Global configuration
Usage
The register checksum defined in RFC is used by default.
Examples
This example shows how to set to calculate register checksum over whole packet.