CANOGA PERKINS CanogaOS Command Reference - Manual (Page 785)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 785 of 855
Command Syntax
show debugging {arp [vrf name] | bgp | chsm | dhcp {relay | snooping} | dot1x | igmp | ipsour
guard | ipv6 nd | nsm | ospf | pim sparse-mode | rip | status | stp | vrrp}
arp For module arp.
bgp Border Gateway Protocol (BGP).
chsm For module chsm.
dhcp For module dhcp.
relay For module dhcp relay.
snooping For module dhcp snooping.
dot1x IEEE 802.1X Port-Based Access Control.
igmp Internet Group Management Protocol (IGMP).
ipsour guard For module IP source guard.
ipv6 nd Pv6 Neighbor Discovery.
ldp Label Distribution Protocol (LDP).
nsm Network Service Module (NSM).
ospf Open Shortest Path First (OSPF).
pim sparse-mode Protocol Independent Multicast (PIM).
rip Routing information protocol (RIP).
status Show debugging status.
stp Spanning Tree Protocols (STP/RSTP/MSTP).
vrrp Virtual Router Redundancy Protocol (VRRP).
Command Mode
Privileged EXEC
Usage
Examples
The following is sample output from the show debugging command.
Switch# show debugging
Related Commands
40.54 ping
To diagnose basic network connectivity on IP networks, use the ping command in privileged EXEC
mode.
Command Syntax
ping [ip-address | ip ip-address | ipv6 ipv6-address | vrf name ip-address]
ip-address The target IP address.