18 enable-ldp – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 477
Advertising
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 477 of 855
25.18 enable-ldp
Use this command to enable LDP on a specified interface.
Command Syntax
enable-ldp
Syntax Description
This command has no arguments or keywords.
Command Mode
Interface mode
Defaults
This command has no default settings.
Examples
In the following example, the enable-ldp command is used to enable LDP on a specified interface:
Switch # configure terminal
Switch (config)# interface eth0
Switch (config-if)# enable-ldp
Related Commands
Advertising